Sentaurus

The Sentaurus Technology Computer-Aided Design (TCAD) tools are installed in the Niagara software stack.

Getting a license

Licenses are provided by CMC Microsystems. Canadian students and faculty can register at this page.

Once you have an account, you must contact CMC and tell them you want to use the Synopsis Sentaurus tools on Niagara, and give them your SciNet username.

Running using the Niagara installation

Sentaurus 2017.09-SP2

Commercial modules can only be accessed using the 'module use' command.

module use /scinet/niagara/software/commercial/modules
module load synopsys/sentaurus/2017.09-SP2

Running Sentaurus

Example submission script for a job running on 1 node, with max walltime of 11 hours:

#!/bin/bash
#SBATCH --nodes=1
#SBATCH --ntasks-per-node=40
#SBATCH --time=11:00:00
#SBATCH --job-name test

module use /scinet/niagara/software/commercial/modules
module load synopsys/sentaurus/2017.09-SP2

# DIRECTORY TO RUN - $SLURM_SUBMIT_DIR is directory job was submitted from
cd $SLURM_SUBMIT_DIR

machines=`srun bash -c 'hostname -s' | sort | uniq | awk '{print $1 ":" 40}' | paste -s -d ':'`
ansys190 -b -j JOBNAME -ppf aa_r -dis -machines $machines -i ansys.in

Running using the CC installation

Ansys 19.0

To access the CC software stack you must unload the Niagara stack.

module load CCEnv
module load ansys/19.0

You can run the script given in the previous section by substituting the previous module commands with the above two.